What are sachets?
Sachets are a new packaging for injectable steroids. The sachets are designed in such a way as to pass any inspection without raising any suspicion. There are no obvious markings on the sachets themselves that would imply the contents - a casual observer would think that the sachet contains some kind of massage oil or other.

Sachet is 2’ wide and 2’ high, and not more than 1/4' thick. Each sachet contains 3.5 ml of steroid. The extra 0.5 ml is because some of the steroid could remain in the sachet or in the syringe... You can also drain the full 3.5 ml of the steroid and you get 0.5 ml for free.

The paper of the sachet is made of many different layers and protects the contents from all outer elements and it meets the highest medical standards. The packing, as long as it's factory sealed, is as good as a glass vial. Steroid packing is very secure and has a shelf life of 5 years.

Each sachet has an imprinted production date in eight digits like 17.07.2006. Followed by 2 or 3 letter code that identifies the product. For example: the whole code is 17.06.2006.TE3, this would mean that the steroid was manufactured on June 17, 2006 and the content is Sustanon. Please check for products codes in table below.

Below is list of products shipped in sachets.

Product name (click on product for details)	Code on sachet
Equipoise 3 ml - BU	BU
Boldenone Mix - BU3	BU3
Masteron 3 ml - DP	DP
Primobolan depot 3 ml - ME	ME
Deca Durabolin 3 ml -ND	ND
Nadrolone Mix 3 ml - ND3	NE3
Nandrolone phenylpropionate - NP	NP
Nadrolone Undecanonate 3 ml - NU	NU
Sustanon 3 ml - TE3	TE3
Testosterone Cypionate 3 ml -TEC	TEC
Testosterone Enanthate 3 ml	TEE
Testosterone Propionate 3 ml - TEP	TEP
Trenbolone Acetate 3 ml - TRA	TRA
Trenbolone Enanthate 3 ml - TRE	TRE

How to open sachet?

1. Before actually drawing out the steroid it is a good idea to worm it up, as the oil is less dense when warm - place it over a hot cup of water and the steam will heat it up in half a minute - don't actually put it in water as you might heat it up too much.

2. Place a needle on a syringe and pierce the corner of the Sachet - only pierce a quarter of an inch deep, and make sure you pierce it at a right angle or the needle will get out on the other side.
   

3. Start drawing the plunger immediately or the oil could drip out at the sides.
   

4. You need to drain the sachet completely - you can't keep the Anabolic inside once you've opened it.

5. If you don't intend to use the whole 3 ml in one shot you can drain the sachet completely and then inject it to a multi-dose vial, and store it for further use. If you don't have a vial at hand, you can also store it in the syringe for couple of days (replace the needle immediately after the shot and put a fresh needle on; keep the syringe in a dry and dark place at room temperature.).

6. Change the needle for injection, because the one you used for the drawing might be damaged.

7. Make sure there are no air bubbles in the syringe. If there are air bubbles, tap the syringe with your finger and let the air bubbles float to the top.
   

8. Push on the plunger of the syringe to move the air bubbles out of the syringe.

9. You are ready to inject the steroid!